Hello Guest it is August 08, 2020, 02:25:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - metalsmithdan

Pages: 1
1
General Mach Discussion / router table refirb, y axis gaining steos
« on: August 15, 2009, 10:34:55 PM »
I have recently acquired an older Gerber router table and have replaced all the steppers and electronics. Running mach 3 through a CandCnc BOB using their screen set. Problem I'm having is that Y axis is gaining steps. Example:While running an engraving text file the line of text has perfect proportion but instead of running straight and parallel it veers up to the right by 5 degrees or so. I have gone through the mechanical several times and can comfortably eliminate any slop, backlash etc. Motors are tuned according to common practice in Mach. I have been doing this CNC mach exorcise for about 4 years and thought I had most of it under stood, but this one is kicking my but. Any Ideas? Dan in New Mexico

Pages: 1