Messages

1

Newfangled Solutions Mach3 Wizards / Re: V2.84 fixes thread mill bug

« on: March 14, 2010, 12:39:41 PM »

Thanks Ron, both for this and all the other maintainenance over the years.

Mike

2

Video P*r*o*b*i*n*g / Re: Video Edge Finder

« on: February 07, 2010, 12:16:11 PM »

I'm supposed to be a beta tester for Tormach's upcoming video prober.

Were you able to test the video prober?  I couldn't find any mention of it on your web site and see that Tormach is taking orders for them now.

Mike

3

FAQs / Re: In need of a low speed spindle motor

« on: November 28, 2009, 04:07:52 PM »

Hw about a Sherline motor?  I'm pretty sure that they sell them as spare parts.

Mike

4

General Mach Discussion / Re: Stupid Questions re: Touch Probe Alignment

« on: November 15, 2009, 01:29:20 PM »

Hood,

Thought I'd confuse things by posting to the correct thread....   

Do you have drawings of your probe?  I have no desire to re-invent the wheel....

Regards,
Ray L.

Have you seen Arnies probe?  At $100+, it makes buy vs make a difficult decision.

http://www.machsupport.com/forum/index.php/topic,5004.0.html

Mike

5

General Mach Discussion / Re: Visual mill vs Sprutcam

« on: September 20, 2009, 11:14:48 AM »

If you are new to CAM you might have problems learning to use it as I did.  The SprutCAM user forum can help you get started but I found that the tutorials offered by Dave (Pearson?) in the UK really helped.

Mike

6

Newfangled Solutions Mach3 Wizards / Re: MachTurn wizards

« on: March 29, 2009, 11:52:17 AM »

Another bug is that the threading wizrd will only thread tapers that are in integral degrees, whereas NPT threads are on fractional tapers.

Mike

7

Newfangled Solutions Mach3 Wizards / Re: 2.83 ready

« on: March 22, 2009, 12:24:07 PM »

Thanks Ron - Mike

8

Newfangled Solutions Mach3 Wizards / Re: 2.83 ready

« on: March 22, 2009, 11:27:30 AM »

Ron,

Will there be a separate version for the Tormach mill?

Mike

9

Newfangled Solutions Mach3 Wizards / Re: V2.81 for Tormach?

« on: December 09, 2008, 08:23:30 PM »

Thanks Ron - Mike

10

Newfangled Solutions Mach3 Wizards / V2.81 for Tormach?

« on: December 07, 2008, 12:36:39 PM »

Ron,

Will you be releasing a version for the Tormach?

Mike