Hello Guest it is March 28, 2024, 04:35:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - leptronjohn

Pages: 1
1
One on one phone support. / Re: About one on one phone support.
« on: July 22, 2015, 12:24:16 PM »
widget master cnc
bob campbell combo break out board
windows 8.1
smooth stepper
mach 3
all lights work, motors are holding... but will not jog         need phone service please..
john
623 327-3968
john@sonoranbreezecreations.com

2
Forum suggestions and report forum problems. / Re: increment changes
« on: August 03, 2008, 01:37:31 PM »
Hood, and overloaded,
i changeded the setting on mach to inches and everything i have been trying to run seems correct. I am making chips enough that i now need to stop and figure how to make the dust collecter fit.

thanks you very much for the help, i feel much better about life today :-)

3
Forum suggestions and report forum problems. / Re: increment changes
« on: August 03, 2008, 12:01:51 AM »
Hood,
gox1 made it run away...
i have no clue how to set the machine to imperial, in my younger days i could talk anything into converting.. oh that was different..
i have no cnc or g code back gound.

thanks for you time it is great.

john oakley

4
Forum suggestions and report forum problems. / Re: increment changes
« on: August 02, 2008, 03:49:08 PM »
Hood,
i have been called to the big city for a couple of hours, job emergency... i will run this tonight and see... thanks you verry much for the help...

5
Forum suggestions and report forum problems. / Re: increment changes
« on: August 02, 2008, 03:30:16 PM »
Hood,
thanks for the help!

6
Forum suggestions and report forum problems. / Re: increment changes
« on: August 02, 2008, 03:00:04 PM »
good morning,
 i am trying to do everything in inches.

7
Forum suggestions and report forum problems. / increment changes
« on: August 02, 2008, 02:17:32 PM »
hi Guys,
i am new to this cnc game and feeling very stupid. my gray hair tells me i should know everything there is, ha.
i am using mach 3 on my new k2 kg-2525 router. if i use  lazy cam for the post processor i have no problem with cutting but...
if i load a job from vectric 2d it changes my mpg units, which of coarse screw up the cutting and caused the machine to run off the stops.
as soon as i load the program from vectric my machines thinks that  0.10 is 2.5 inches. if i close the job and restart the mach 3 all the increments are ok again, as soon as i load from vectric is does it again...

what the...  john

Pages: 1