Messages

1

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: September 03, 2010, 07:56:39 PM »

Where is information on customizing Mach3.

2

General Mach Discussion / computer overscans page

« on: January 14, 2006, 08:13:01 PM »

I have a laptop that does not drive the cnc very well, but presents the entire opening screen Mach3 in a satisfactory manner.  (XP home)
I have a desktop that tests well on the waveshape tester, but over scans the opening screen to present only 80% of the screen. The right hand side is unusable and the bottom is unuable.  ie. I cannnot see "reset" etc.  This computer is running XPro.

Any suggestions?

thanks

cncbailey

3

General Mach Discussion / optimization of xp pro

« on: December 11, 2005, 11:20:46 PM »

I AM TRYING TO USE THE OPTIMISATION XP.TXT.  i GOT HUNG UP ON THE REGISTRY CHANGES WHERE I RECEIVED A MESSAGE... (AFTER RUN REGISTRY.EXE) "THE KEY WILL BE RESTORED ON TOP OF THE KEY: MY COMPUTER. ALL VALUES ENTRIES AND SUBKEYS OF THIS KEY WILL BE DELETED.   dO YOU WANT TO CONTINUE THE OPERATION  y/n.  i DID ALL THE OPTIMAZATION UP TO THE REGISTRY.  i JUST RAN THE TEST PROGRAM ON MACH3 AND NOTHING APPEARS IN THE TEST WINDOW. THIS MACHINE IS A 2.7 MHZ XP PRO PROGRAM.  ALL HELP WOULD BE APPRECIATED !
CNCBAILEY