Hello Guest it is September 20, 2019, 06:40:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - andypasko

Pages: 1
1
General Mach Discussion / Re: Mach Turn
« on: August 31, 2006, 04:22:50 PM »
I use BobCad V20 for the g-code.  Support page on their website has post for Mach3 Turn.

2
General Mach Discussion / Re: Mach Turn
« on: August 30, 2006, 07:18:25 PM »
Disregard... i got it to work.

3
General Mach Discussion / Mach Turn
« on: August 30, 2006, 03:17:08 PM »
How do I perform a finish pass on Mach turn ?   Any help would be appreciated.

Pages: 1