Hello Guest it is December 04, 2021, 03:47:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jimmyp

Pages: 1
1
General Mach Discussion / Re: external estop problem
« on: February 02, 2009, 10:00:08 AM »
That was the problem.  It is running a test program now.  I'll let you know when it finishes.

Many thanks

JimmyP

2
General Mach Discussion / Re: external estop problem
« on: February 02, 2009, 09:54:27 AM »
I'll try now.  Thanks

JimmyP

3
General Mach Discussion / Re: external estop problem
« on: February 02, 2009, 08:32:59 AM »
This is driving me bonkers.  Thanks ahead for taking a look

JimmyP ??? ???

4
General Mach Discussion / Re: external estop problem
« on: January 31, 2009, 11:33:50 AM »
No I check the pin step ups and they are correct.  It does have an estop button but It is far enough away not to cause a problem.  It is the power supply that Bob Campbell makes.  Thanks though

JimmyP

5
General Mach Discussion / external estop problem
« on: January 31, 2009, 11:21:26 AM »
I just installed the latest Mach version on my computer and have a constant estop error on the zed axis only.  I have disabled the limits and everytime I hit a G1.  I receive an estop.  Talked with Bob Campbell and he suggested I throw out here for some help.

JimmyP ???

6
General Mach Discussion / Re: newbie question
« on: April 21, 2008, 11:23:40 AM »
Chip, thanks for taking the time to help me.  I have attached the screen shot and .xml file.  I am running R2.63.

Jimmy P

7
General Mach Discussion / newbie question
« on: April 20, 2008, 09:24:22 PM »
I have finally figured out the three axis and every time I try to flip the fourth it bomgs.  I have a sherline 3700 on the fourth axis on a minitech 2 machine.  I finally figured out how to configure the other three axises(sP), but when I sent a jog or flip to the fourth axis I have an external stop.  I have tried setting the limits to 360 plus and minus and it still bombs. Also, under the diagnostics I have tried moving the a axis and have an external stop everytime I pass 10 degrees.   I have searched the tutorials and videos and can figure this one out.  What can I try next.

Jimmy P.

Pages: 1