Hello Guest it is September 29, 2020, 08:04:46 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Fawaad

Pages: 1
General Mach Discussion / Re: PID In MACIV
« on: August 31, 2006, 03:53:12 PM »
Plz see this application note for DC Servo Motor by microchip(www.microchip.com).


This code uses RS-232 commands(Data being in quadrature encoder pulse units) to move the DC Servo motor to desired position. The velocity and acceleration are also programmed via Serial Interface into PIC MCU.

Can we make MECHIV to send position data in the form of serial commands on COM Port(RS 232), rather than generating pulses at certain velocity on Parallel Port, to move the motor to desired position.

General Mach Discussion / PID In MACIV
« on: August 27, 2006, 12:33:13 PM »
   I am basically an embedded system programmer and currently working on developing a Driver module for Step and Direction based DC Servo Motor control system. I wanted to know if MACIV has built in implementation of PID control loop for DC Servo Motors or do i need to implement it in the Driver Module.

Pages: 1