1
General Mach Discussion / Re: Parts are not correct size!
« on: April 15, 2009, 06:25:24 PM »
Sorry for the delay in updating this ...been busy !!
From what I have been told this is a bug that they have been trying to find for a while now ... apparently it only ‘pops up’ now and then and may involve code which utilises G28.1, G92, subroutines and offsets (all in the same code file).
A couple of days after starting that post I ran another job which uses all of the codes in the one file – it ran perfectly... as have others since. There seems to be no logic to which code it will effect which makes it very difficult to work around ... at least if it always did the same thing to each and every file you could code around it or take it into consideration when first designing your part.
Apparently the driver section of the new Version 4 is totally re-written and should have no issues.
From what I have been told this is a bug that they have been trying to find for a while now ... apparently it only ‘pops up’ now and then and may involve code which utilises G28.1, G92, subroutines and offsets (all in the same code file).
A couple of days after starting that post I ran another job which uses all of the codes in the one file – it ran perfectly... as have others since. There seems to be no logic to which code it will effect which makes it very difficult to work around ... at least if it always did the same thing to each and every file you could code around it or take it into consideration when first designing your part.
Apparently the driver section of the new Version 4 is totally re-written and should have no issues.