Hello Guest it is April 01, 2020, 07:06:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shawn_clmachine

Pages: 1
1
Look for a toolmakers microscope. Be careful to make sure that the crosshairs are centered when you use it.

2
Modbus / Re: Mod I/o Question
« on: October 16, 2006, 11:45:05 PM »
I'm going to use my for front panel stuff.

Feedrate Override, Spindle Override, MPG, buttons ....

3
General Mach Discussion / Re: Automatic Oiler
« on: October 16, 2006, 08:04:38 PM »
My machine already has an automatic oiling system plumbed and powered, it just needs to have a relay triggered to initiate an oiling. One of the outputs from Mach3 could be used to do this, if I had a way to tell it when.

Shawn
 

4
General Mach Discussion / Automatic Oiler
« on: October 16, 2006, 12:21:53 PM »
What is the best way to implement an automatic oiling function. It. would be better for it to happen after a certain amount of motion rather than time. I saw a post about using the macropump to do this. Can someone elaborate on this please?

Shawn

5
General Mach Discussion / Standard Configurations
« on: September 28, 2006, 01:55:09 PM »
Are there any standard configurations recommended? I mean for the assignment of ports/pins to a function. I would like to get my project started right from the beginning.

Shawn

6
Show"N"Tell ( Your Machines) / Re: Chads new machine
« on: September 18, 2006, 11:19:11 PM »
Chad this is an amazing accomplishment. I am proud of you.


7
General Mach Discussion / Re: Retrofit problems.
« on: September 18, 2006, 01:14:36 AM »
I agree, the Gain adjustment is very touchy.

8
General Mach Discussion / Re: New here and have a few questions
« on: September 18, 2006, 12:31:55 AM »
Anyone have experience or knowledge to compare the Skyko and Rutex products?

9
General Mach Discussion / Re: Galil
« on: September 14, 2006, 12:23:13 AM »
Anyone else out there going to be using Mach with a Galil when it is operational?


10
General Mach Discussion / Galil
« on: September 07, 2006, 12:52:44 AM »
I am very interested in the progress being made on a Galil compatible Mach. Can we get a teaser or two?

Shawn

Pages: 1