Hello Guest it is March 28, 2024, 03:43:27 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Adam Fritzsche

Pages: 1
1
General Mach Discussion / Re: Saving Machine Coordinates?
« on: January 04, 2012, 09:28:01 AM »
Thank you, that should help me temporarily solve my issues, and thank you for the insight. I really do want to figure out the limit switches (they are shielded, properly grounded, have installed capacitors as recommended by others, and used the debounce) so I can home that way, as I think it is even more important to use them for homing as I have a slaved axis and would help prevent any slight racking that may occur.

2
General Mach Discussion / Saving Machine Coordinates?
« on: January 04, 2012, 08:24:03 AM »
Good morning. First off I want to appologize as I am sure this topic has bound to have come up, but I just could not come up with a relevant search.

I have set my machine coordinates manually (have limit swtiches that could be used to home, but they constantly give me false trips) where they need to go, and have set up all my soft limits. I have noticed that when I shut mach down and restart, I have lost all reference to the previous machine 0's.

For example if I move to a spot of machine coordinates of X:10, Y:10, restart mach, now this position has become the new machine 0,0.
Is there a way to save the actual spot that I previously left the machine at, or am I going to have to set new machine zero references everytime I shut down mach?

Pages: 1