Messages

1

General Mach Discussion / Re: Change speed and zero fifth axis

« on: December 15, 2006, 11:56:37 AM »

I will try the the 5th axis screen design
Thanks
Eric

2

General Mach Discussion / Change speed and zero fifth axis

« on: December 13, 2006, 05:29:21 PM »

Friends:

I can not change the move speed by the F code and do not know how to zero the fifth axis.

A 5-axis CNC router is driven by Yaskawa servo motors and all axes are worked fine except the speed are too slow.

Thank you for any advice.

Eric Ma

Eric1ma@yahoo.com

3

General Mach Discussion / Re: Servo motor configuration

« on: August 24, 2006, 12:04:07 PM »

Hi Chip:
The wiring of the amplify for a servo motor is pretty complicated

I am working on the Yaskawa servo motors. There are 50 connectors in amplifies terminal.

Could you please direct me that which two connectors should be wired to the two parallel pins?

I am very appreciated your help!

Eric

4

General Mach Discussion / Servo motor configuration

« on: August 23, 2006, 07:32:09 PM »

Is anybody knows how to hookup the servo motors with Mach3? How many pins are needed to control one amplifier of the servo motor?

I have five servo motors and two parallel ports in my computer. Is the Mach3 is powerful enough to handle all the five servo motors?

Thanks a lot!

Eric Ma

5

General Mach Discussion / Re: Interface bwteen the parallel ports and Servo motors

« on: August 23, 2006, 04:31:17 PM »

Thanks:
I will order the CNC4PC board.

6

General Mach Discussion / Re: Interface bwteen the parallel ports and Servo motors

« on: August 18, 2006, 01:52:12 PM »

I am unable to contact with  Bob C. He is alway on vacation?
do you know his phone number?
Thanks

7

General Mach Discussion / Interface bwteen the parallel ports and Servo motors

« on: August 17, 2006, 03:43:34 PM »

Friends:
I need a breakout board to interface the parallel port and Yaskawa servo motors (Amplifiers).

I am working on a project of 5 axis CNC router.
Is any commercial breakout board available?

Thanks