Hello Guest it is March 28, 2024, 09:46:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Tom Nelson

Pages: 1
1
General Mach Discussion / Help
« on: April 13, 2008, 04:45:42 PM »
I have ran the driver test program and for pulses per second in 25khz I'm getting from 95 to 97  I don't know if its any help but the cpu speed is 799 and the light for "Apic is present" is lit.
I can move the motors but very slowly. I have uninstall the driver and reinstalled and rebooted but no help.
I see lots of questions but with no answers on this site. I hope for so help!!!!!!!!!!

Tom

2
FAQs / Help
« on: April 06, 2008, 01:45:30 AM »
???
I have ran the driver test program and for pulses per second in 25khz I'm getting from 95 to 97  I don't know if its any help but the cpu speed is 799 and the light for "Apic is present" is lit.
I can move the motors but very slowly. I have uninstall the driver and reinstalled and rebooted but no help.
I see lots of questions but with no answers on this site. I hope for so help!!!!!!!!!!

Tom

Pages: 1