Guest
Show Posts
1
Show"N"Tell ( Your Machines) / Re: Help! Hardinge CHNC Retrofit
« on: March 29, 2008, 09:22:54 AM »
thanks Dennis,
Ya i think i will take the cash.
On the cubloc what one do you recommend?
and what else will i need to get the cubloc going?
The motors are still good on this machine and i have extras so i would like to use them.
machmotion tells me there is a gizmo i can hook to the tac/resolvers that will translate the signal. butt I'm not sure what it is called.
my biggest problem with this retrofit is that i have an order do next week and that job was suppost to pay for this machine so right now I'm looking for the fastest and cheepest way to get that job out.
It's like retrofit 911 lol.
thanks again
Brian's machineshop
Ya i think i will take the cash.
On the cubloc what one do you recommend?
and what else will i need to get the cubloc going?
The motors are still good on this machine and i have extras so i would like to use them.
machmotion tells me there is a gizmo i can hook to the tac/resolvers that will translate the signal. butt I'm not sure what it is called.
my biggest problem with this retrofit is that i have an order do next week and that job was suppost to pay for this machine so right now I'm looking for the fastest and cheepest way to get that job out.
It's like retrofit 911 lol.
thanks again
Brian's machineshop