Messages

1

FAQs / Re: Breakout board

« on: March 27, 2011, 04:54:23 PM »

Are there any more options for a good breakout board.
bad manual for such a good looking card.
i read a lot of troble hook up the wirering  becourse of the bat manual.

Jan

2

FAQs / Re: Breakout board

« on: March 23, 2011, 05:20:01 PM »

Thank for the replay i think i go for the C11 

3

FAQs / Breakout board

« on: March 20, 2011, 06:24:20 PM »

Hello All
I Do Need a breakout board there are so manny i do not now what ik must get i ask jou for advice on this what is the best choice
i whant a good board for 4 drives, limit and  home connectors.

jan

4

General Mach Discussion / Re: cnc4pc multifuncion cnc board

« on: January 09, 2010, 08:01:04 AM »

Ok this drive MSD-32V-8 i mean or wil dis to be ligcht

http://www.stappenmotor.nl/Datasheets/microstapdrivers%20info/MSD-32V-8.htm
or this whane

http://www.stappenmotor.nl/Datasheets/microstapdrivers%20info/MSD-50-5.6.htm

Japan Servo KH56QM2-951
link steppers    http://www.mechapro.de/motor-e.html

5

General Mach Discussion / Re: cnc4pc multifuncion cnc board

« on: January 08, 2010, 03:19:53 PM »

No one hoe have a answer for me wat is the best combination for the c11 board

6

General Mach Discussion / cnc4pc multifuncion cnc board

« on: January 07, 2010, 05:04:48 PM »

Hallo
i have a cnc4pc multifuncion cnc board C11 can some whane tel me wat i have to use for driver to de steppers  I use the t x-y As   Japan Servo KH56QM2-951
Z As  23LM-co77-02v  what is the best option to use  i think this wil be ok  driver MSD-32-2.5?

GR Jan

7

General Mach Discussion / Re: Limit Switch Problems

« on: July 02, 2008, 04:38:09 PM »

Hello Brett

The machine is a  Zoltar    http://www.zoltar-cnc.nl/?p=classic

8

General Mach Discussion / Re: Limit Switch Problems

« on: July 02, 2008, 11:14:34 AM »

Hallo I have also a problem whith te swithes when i have the home the good direction then the axis go the wrong way , when i change that de then the functions on the keybord are wrong

9

General Mach Discussion / Re: cnc machine running when start windows 2000

« on: April 27, 2008, 02:39:49 PM »

Hallo i have a pci lpt port instald in de the pentium 4 and now it works any whan a idee how i get the original port to work   

10

General Mach Discussion / Re: cnc machine running when start windows 2000

« on: April 23, 2008, 11:00:09 AM »

Have you tried looking at your voltage coming out of the port? Have you run the DriveTest to see if the pulse is good? Have you tried tuning your motors?
Hood

1 check voltage no 2 drivertest yes 3 tunning motors yes on the pentium 3 its ok with PCNC not with mach3  thats i thing the system is to low
I will check the votage on the pentium 4