Hello Guest it is March 28, 2024, 06:25:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - knuckle_

Pages: 1
1
General Mach Discussion / Re: CNC PEOPLE LOCATIONS
« on: September 12, 2008, 10:29:40 PM »
Sticky posts .............Camphellsport WI  _here_ our strength surface!  It's all bratz an krout here.  Wilburr where are you at? relative the gitchigoomi?

2
terrific blades !! did you model these from scratch or ? I am interested in developing  blades similar....for wind turbines.  I would appreciate feedback on Vcarve tool path development.

Mark

Pages: 1