Hello Guest it is March 28, 2024, 06:12:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - le_frenchy

Pages: 1
1
Forum suggestions and report forum problems. / Driver Test Problem
« on: March 22, 2008, 07:19:11 PM »
The first time I ran Mach3, it crashed on me, as explained in the video tutorial, rebooted used the “Special driver” file and fixed the problem of crashing.
Started the Mach3 again, no problem, ran the “driver test” looked okay, I could see the curve.
Then went on configuring the ports and pins and motor tuning.
I tried to move the only one drive I had hooked up, but without any success, trying to jog, nothing, the motor wouldn’t turn, nor did the value on the screen wouldn’t budge.
I re-did a “driver test” this time no curve and got the error message “Could not locate missing vectors”
Any suggestion? Please

Pages: 1