Messages

1

General Mach Discussion / Re: help with torch relay!

« on: March 31, 2008, 08:44:03 AM »

Hello,
i'm using the relay from cnc4cp connected on port 1 on the board. It will switch it on when i press the torch on off button but it will not turn it off.

2

General Mach Discussion / help with torch relay!

« on: March 30, 2008, 03:02:55 PM »

hello everybody,
I have my relay connected to control the plasma torch and mach3 will switch it on but it wont go off.  If i take one of the wires off and put it back
the relay will switch off. Is it something in the configuration that i've missed cause the relay has no fault!
Please help me out!
Thanks

3

G-Code, CAD, and CAM discussions / Re: Cutting same thread twice!

« on: March 28, 2008, 01:41:15 PM »

My mistake.
I wanted to say chain instead of thread!!
It will go over the same cut twice.

4

G-Code, CAD, and CAM discussions / Re: Cutting same thread twice!

« on: March 28, 2008, 01:38:13 PM »

I use corel draw X4.
Thanks

5

G-Code, CAD, and CAM discussions / Re: Cutting same thread twice!

« on: March 28, 2008, 01:01:20 PM »

Here is another g-code,

6

G-Code, CAD, and CAM discussions / Re: Cutting same thread twice!

« on: March 28, 2008, 12:58:48 PM »

Dear friend,
this happens to all g codes posted from lazycam.

7

G-Code, CAD, and CAM discussions / Cutting same thread twice!

« on: March 28, 2008, 12:32:04 PM »

Hello everybody,
simple question for you guys!!!
Why is mach 3 cutting the same thread twice??
I know that it's something to do with the settings in lazycam but i dont know where to look.
please help me out!
Thanks

8

General Mach Discussion / Re: g-code problem after loading to mach3

« on: March 22, 2008, 08:14:13 AM »

Found the problem!!!!
Beware of  windows installer 3.1 [ kb893803]
When instaled, disable the driver of mach 3 cause it will cease it.
thanks

9

General Mach Discussion / Re: g-code problem after loading to mach3

« on: March 20, 2008, 03:50:42 PM »

it's a simple newbie cut!

10

General Mach Discussion / g-code problem after loading to mach3

« on: March 20, 2008, 09:17:16 AM »

hello, everyone,
i'm having a problem when i load a g-code from lazy cam to mach 3. The thing is that when i load it the first time i can see it all without any problems with the g-code. If i close mach 3 or regenerate it, then i can only see half of the image and the g-code is  bad!
am i missing something?
please help!
thanks in advance!