Hello Guest it is September 22, 2023, 03:32:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jordie1944

Pages: 1
PoKeys / Re: setting up input for oemcode
« on: January 21, 2010, 01:19:08 AM »
The 4axisPendant.rar contains a .pkc file can you please tell me how to open it.


Brains Development / Re: How to run a Brain triggered Macro.........
« on: January 20, 2010, 08:13:21 PM »

Could you please explain the User Button in the Brain a bit more. I could not find any terminators for User Button.

Also how does the User Button associate with the macro? I would like to run a Zero tool macro from a brain triggered from a modbus or pokeys switch.


General Mach Discussion / Ref all Home
« on: April 20, 2008, 03:00:14 AM »
When I ref all home, the x and y axis move to the home switch a back off a small distance which is noticeable.
The Z axis moves to the home switch but there is no visible back off.

Is this normal?

Thanks Mike

Thanks TP that solved the problem

Yes something like that.
I have a tool change macro that Requests the router to turn off, measures the current tool, then asks for the new tool to be inserted, at this point I would like to get the tool description for say T9, nine in the tool table to be displayed in the message ie. " change tool to 3.1mm Mill".


General Mach Discussion / How to get information from tool table Mach3
« on: March 20, 2008, 02:11:34 AM »
I would like to know how to get information out of the tool table for use in a tool change macro.

Specifically the tool description.


Pages: 1