Hello Guest it is March 28, 2024, 06:38:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ilkkahy

Pages: 1
1
General Mach Discussion / Re: Setting up mach3
« on: March 19, 2008, 10:26:50 AM »
I now have two motors on x-axis but i dont know how to change another motors rotation direction? I suppose this is possible to do with mach3 so that i dont have to re-wire slave motor again?

2
General Mach Discussion / Re: Setting up mach3
« on: March 18, 2008, 01:18:13 PM »
Thanks matey. However i accidentaly got the motors working by enabling "Max cl mode". Any clue what it stands for? I also needed to take dir low active off... have no idea what that means either. Step low active had something to do with opto isolation eh?



I guess ill just need to start get familiar with cam programs now...

3
General Mach Discussion / Setting up mach3
« on: March 18, 2008, 10:18:46 AM »
Hello. I have four little six wired step motors with these M109 modules and M108 interface switch to connect them to printer port in motherboard (0x378 i suppose). There came small program with the modules that i can run motors with just fine but i havent got Mach3 working yet.

http://www.kemo-electronic.de/en/module/m109/index.htm
http://www.kemo-electronic.com/en/module/m108/index.htm

Here is picture of my ports and pins section. I have disabled e-stop but it didnt help.



Is there some larger tutorial that would contain information about each and every setting?

Pages: 1