Messages

1

FAQs / Re: Mach3 reboots..

« on: March 17, 2008, 03:29:34 PM »

Thank you bcromwell.I will try and inform you about the results!

2

FAQs / Mach3 reboots..

« on: March 17, 2008, 10:41:48 AM »

Hello everybody.I am new in the would of cnc and this is my first topic.My first project is the convention of Proxxon MF70 micro mill to cnc.
A friend give me his old PC and I am going to use it as a dedicated PC for controlling the mill.It is a Pentium 3 800MHz,20 GB HD,256MB ram and voodoo graphic card with XP Sp2 o.s.
The problem is that every time I try to open mach3 first I see the artsoft logo on screen and then the PC reboots.
The installation of new mainboard drivers(Via hyperionPro) and the use of the optimization file for XP did not help.
I hope that you can help me with this problem!
Best regards.
P.S.Sorry for my poor English.