Hello Guest it is March 28, 2024, 06:42:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - carleldredge

Pages: 1
1
General Mach Discussion / Re: Saving DRO Values
« on: May 04, 2008, 08:56:20 PM »
I am creating a semi-closed loop control for mach3. I just need to be able to save some settings that are send out to MCUs via the SmoothStepper. It is too much hassle to enter the settings in every time you start up mach.

I don't know why,  but some of the user DROs I created are saved when mach3 is closed. Others are not. Any ideas? I really need to figure this out.

Thanks a lot,

Carl

2
General Mach Discussion / Re: Saving DRO Values
« on: May 03, 2008, 09:10:47 PM »
I have that selected, but it does not save all of them. I don't know if it makes a difference, but I'm using a macro to write to the DROs.

3
General Mach Discussion / Saving DRO Values
« on: May 03, 2008, 08:33:21 PM »
Does anyone know how to save user DRO values in mach3? I need to save some values when mach3 is closed and use them again the next time it is opened. Is there a way to do it in a plugin? If so, how?


Thanks,

Carl

4
General Mach Discussion / Re: DRO # for Steps Per Inch/mm
« on: April 04, 2008, 11:16:55 AM »
That did it. Thanks so much!

Carl

5
General Mach Discussion / Re: DRO # for Steps Per Inch/mm
« on: April 03, 2008, 04:01:55 PM »
I'm sorry, I should have been more specific. I need to use the value in a brain, so I want an address or DRO number. Other wise, every time I change it I'll have to do it twice. I'm trying to design a new screen.

Thanks.

Carl

6
General Mach Discussion / DRO # for Steps Per Inch/mm
« on: April 03, 2008, 11:48:45 AM »
Hi,

I need to be able to access the number of steps per inch/mm. The DRO is located under Config-Motor Tuning. If anyone knows how to get that number, please tell me.

Thanks alot. :)

Carl

Pages: 1