Hello Guest it is April 11, 2021, 09:00:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - bongo

Pages: 1

I had a similar sounding problem with the C11 BOB. I would hear some noise from the motor as if it was turning but it was basically locked apart from some random "jumps". The answer was so simple it turned out, yes very red faced me. :-[  I used the XML file from CNC4PC webpage and it turned out the STEP/DIR pins were reversed. I assumed it was correct and then went on to look at hardware problems.
I dunno if it applies to the C10 however.

Hope it helps. :)

General Mach Discussion / IMS Driver and JOG+/- inputs
« on: March 13, 2008, 08:43:07 AM »
Hi all,

I was wondering if anyone had experience with drivers such as the IMS 483I that have JOG+/JOG- inputs instead of STEP/DIR.

Question is;

Can Mach3 covert STEP/DIR to JOG+/JOG- outputs for such drivers or will I have to hardware decode the Mach3 outputs? ???

Pages: 1