1
G-Code, CAD, and CAM discussions / Re: Is any one using Fearture Cam?????
« on: July 31, 2006, 10:12:54 PM »
Brian,
Thank you for the help and support. I did run a part on a self built gantry using the mill post you sent me and it worked great. I am in no real hurry for a lathe post but it would be helpful, I can run my lathe using a fanuc 6 post but I spent a lot of time editing the code. So if and when you get the chance that would be just fine. Thanx again
Thank you for the help and support. I did run a part on a self built gantry using the mill post you sent me and it worked great. I am in no real hurry for a lathe post but it would be helpful, I can run my lathe using a fanuc 6 post but I spent a lot of time editing the code. So if and when you get the chance that would be just fine. Thanx again