Hello Guest it is September 20, 2019, 04:23:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ringram2077

Pages: 1
1
General Mach Discussion / Re: Auto Zero Script Not Profile Specific
« on: April 15, 2016, 09:34:18 AM »
Gerry
That solved my problem :)
Thanks

2
General Mach Discussion / Auto Zero Script Not Profile Specific
« on: April 14, 2016, 03:17:15 PM »
Hi
It appears to me that the same auto zero script loads not matter what profile I use. I have three machines connected to the same PC so I would like to have a separate auto zero setup for each one. When I edit the script in one profile it changes in the others.  I thinking maybe the is tied to the particular screen I am using.  How can I do this?

Thanks
Richard

3
General Mach Discussion / Re: Wierd Font Issue
« on: March 07, 2008, 07:07:24 PM »
Yes, this is the problem xml.  If I recall correctly this issue did not show up initially rathern after I had opened it a few times.

Richard

4
General Mach Discussion / Re: Wierd Font Issue
« on: March 07, 2008, 06:27:11 PM »
The xml the profile I created is attached.

5
General Mach Discussion / Re: Wierd Font Issue
« on: March 07, 2008, 04:34:26 PM »
Chip, thanks for the reply.  I loaded the test screen but no change.  The y axis font still is bold compared to the others.  This is more of an anoyance than anthing since mach works fine.  Just doesn't make sense.

Richard

6
General Mach Discussion / Re: Wierd Font Issue
« on: March 07, 2008, 11:05:40 AM »
Ok, I put in a new video card but it did not fix the issue with the y axis font.  One thing to note is that I created a profile under mach3loader.  If I run mach3mill the fonts are all normal as they should be.  Go figure ??

7
General Mach Discussion / Re: Wierd Font Issue
« on: March 03, 2008, 07:57:38 PM »
Tried your suggestion but it did not fix the issue.  I think I will try another video card and see if that does the trick.

8
General Mach Discussion / Wierd Font Issue
« on: March 03, 2008, 09:48:08 AM »
Running Mach3 2.63 and all is well except the font on the DRO for the y-axis is different than the x and z axis.  I don't see how this can be.  I've tried to change it but always comes up different.  See the attached screen shot.

 ???

Richard

Pages: 1