1
General Mach Discussion / simple AC servo speed control?
« on: August 29, 2008, 01:47:03 PM »
Hello to all
I'm pretty new to this, so please bear with me!
I have a nice sized AC Servo motor that I would like to use to drive a grinding spindle.
The label says 200 volts and 200 watts.
There are 4 wires coming from the motor. I'm not planning on using the encoder.
I thought I read on another forum, where it's possible to drive this motor with a "Flux Vector" VFD.
Has anyone tried this approach?
Thanks for your input!
I'm pretty new to this, so please bear with me!
I have a nice sized AC Servo motor that I would like to use to drive a grinding spindle.
The label says 200 volts and 200 watts.
There are 4 wires coming from the motor. I'm not planning on using the encoder.
I thought I read on another forum, where it's possible to drive this motor with a "Flux Vector" VFD.
Has anyone tried this approach?
Thanks for your input!