Hello Guest it is October 20, 2019, 08:58:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Yodawill2000

Pages: 1 2 3 4 5 6 7 8 9 10 11 »
1
General Mach Discussion / Re: Limit Switch Problems - BAFFLING!
« on: February 21, 2007, 10:45:03 AM »
put 1100 in there and I bet ya a donut your problem is solved   ;D

I have shielded everything and a earth ground to everthing and I still had to make that tweak.

2
General Mach Discussion / Re: Limit Switch Problems - BAFFLING!
« on: February 20, 2007, 05:43:50 PM »
I had the same issue and as Hood said raising the debounce fixed it right up !!

3
General Mach Discussion / Re: Hot Rod Machining
« on: February 02, 2007, 04:56:32 PM »
What are you getting yourself into Brett !!!

looks like fuuuun    ;D

4
General Mach Discussion / Re: CPI-LPT plug-in cards
« on: January 22, 2007, 04:56:51 PM »
I would think the deal breaker is whether the card is a 5 Volt card or the newer 3.6 Volt.
Mach likie 5 volts  ;D

5
General Mach Discussion / Re: Is this drawing too much for LazyCam?
« on: January 02, 2007, 03:37:03 PM »
Weird ..
I created a folder named Mach3 and copied LCam and the drawing in there ..
Same error.
No biggie ..  Just wanted to see what it was all about !!   ;D

6
General Mach Discussion / Re: Is this drawing too much for LazyCam?
« on: January 02, 2007, 02:38:31 PM »
Does LCam have to be loaded on the same PC as Mach ??
Crashes everytime I try to open any dxf ,  even the one listed above ?

Get that window where it ask ya to let Microsoft know about the problem thingie .
Then shuts LCam down ..
Already reinstalled/downloaded

7
General Mach Discussion / Re: So now what????
« on: January 02, 2007, 09:10:45 AM »
Wurde  ;D

8
General Mach Discussion / Re: Custom Icons, How?
« on: December 27, 2006, 11:48:11 AM »
Yes  ,, they are .ico files.

9
General Mach Discussion / Re: Custom Icons, How?
« on: December 27, 2006, 08:51:03 AM »
Yeah ,, what he said   ;D

Email me if you have a need for photoshop tweakage.

10
General Mach Discussion / Re: tuning steppers in mach 3
« on: November 27, 2006, 05:24:57 PM »
Or get a 48V fan   ;D

Pages: 1 2 3 4 5 6 7 8 9 10 11 »