Hello Guest it is March 28, 2024, 06:32:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ultra

Pages: 1
1
Your response was very helpful and worked. Thanks. What I notice is when Windows boots up the spindle is on by default. This is a very big saftey issue. Is there anyway to control the spindle before and after Mach3 is run?

2
General Mach Discussion / What kind of relay to use.
« on: July 28, 2006, 03:42:28 AM »
What input values should a relay be rated for turning a spindle on and off with Mach3? Is there a particular brand and model you could recommend?

3
Some assistance in setting up an estop switch and router relay for an Xylotex 3 axis drive would be appreciated. The control for the spindle will not require anymore than turning on and off with G code and. I have a functioning switch for the estop which is just like the Mach3 manual shows and works off of pin 10. I have had no success in getting a relay for a router to work using pin 1. I want to coordinate the estop and router so that the axis motors and router stop when the estop switch is activated. Also some help setting up Mach3 would be appreciated. I tried to set the software up according to the Mach3 manual but am at the point of trial and error.

Pages: 1