Hello Guest it is December 02, 2021, 01:10:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - spinstack

Pages: 1
1
General Mach Discussion / Re: Reto-fitting Dyna 2400
« on: March 04, 2008, 06:05:40 PM »
So, all i need is a board? what kind of board and where do I buy and how much?
I really appreciate your help.
Pat

2
General Mach Discussion / Re: Reto-fitting Dyna 2400
« on: March 04, 2008, 12:44:00 PM »
Jeff,
When you say OEM steppers and drivers, are you referring to what I currently have?

3
General Mach Discussion / Re: Reto-fitting Dyna 2400
« on: March 01, 2008, 11:04:59 AM »
Jeff,
Thanks for the reply. Your machine is truly a little Frankenstien! I am very impressed. I would like to duplicate what you have done. My machine was in storage for the last 6 years and I was amazed that it started up right away. The controller reminds me of my sprinkler controll box and is somewhat pre-historic. It came with a full set of collets and wrenches. All of this for $100.00!
I already have the Mach 3 software and have recently started on a MasterCam post. I have been machining, programming and engineering for over 30 years. But the thought of doing  anything electrical puts me into a deep coma.
Any advice that you have would be greatly appreciated.
Thanks
Pat

4
General Mach Discussion / Reto-fitting Dyna 2400
« on: February 24, 2008, 09:31:04 AM »
Hello everyone,
I purchased a Dyna 2400 recently and would appreciate any advise on how to go about upgrading to Mach 3 and a list of recommended items.
Thank you in advance,
Spinstack

Pages: 1