Hello Guest it is June 24, 2019, 08:40:23 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - cedarlake

Pages: 1
General Mach Discussion / Bobcad V21 Post Processor
« on: November 07, 2016, 09:48:13 PM »
My hard drive crapped out on my cnc computer so I had to replace it and reinstall all software.  I backed up almost everything, but not my post processor that I had downloaded.  Bobcad only has V25-29 available on their website and Artsoft has one for v18 mach 1.  Maybe that will work for me, I don't know. Will that work for me?

My name is Dave.  I own or co-own or own two woodworking businesses.   The first business which I co-own is a log furniture business www.glrustics.com.  Business has slowed up quite a bit in the last few years, so my business partner and I have started separate businesses to supplement our income. I bought a used Sidewinder cnc and have been trying to make some improvements to it.  I have been doing all of this in my spare time so it isn't going very quickly. 

I have been observing for almost a year now and haven't really had anything to post.  I have enjoyed reading the wealth of knowledge here and appreciate everyone's posts.  I used to work at a place that had a Digital Tools cnc router which isn't the most sophisticated cnc, but I was really amazed by what people were building in their garages when I stumbled upon this site and cnczone.

Pages: 1