Guest
Show Posts
1
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: October 07, 2008, 03:09:47 AM »
Hi all,
I've been around for quite a while, just reading, as I don't have CNC on anything yet. I intended initially to use it with my Myford ML7 lathe, and have some stepper motors, an Advantech embedded PC104 computer put aside for this.
I keep on getting sidetracked, I've been following the development of E-LeadScrew, but I think Mach is more suitable for my lathe.
I also like the idea of the Quorn tool and cutter grinder, and the thought of using CNC to control that is tempting, although I will need to make a Quorn first!
I have loaded and dry-run Mach s/w and I like the ease of the interface, so I intend to make use of it, just got to stop sitting here reading...
I've been around for quite a while, just reading, as I don't have CNC on anything yet. I intended initially to use it with my Myford ML7 lathe, and have some stepper motors, an Advantech embedded PC104 computer put aside for this.
I keep on getting sidetracked, I've been following the development of E-LeadScrew, but I think Mach is more suitable for my lathe.
I also like the idea of the Quorn tool and cutter grinder, and the thought of using CNC to control that is tempting, although I will need to make a Quorn first!
I have loaded and dry-run Mach s/w and I like the ease of the interface, so I intend to make use of it, just got to stop sitting here reading...