1
Mach3 and G-Rex / Re: Communications error starting Mach3 with G100
« on: February 09, 2008, 06:48:42 PM »
Hello,
The problem with not being able to connect to the mach software was a configuration in the mach software, not all the six axis were enabled.
This gives the error I got, now I`am able to use it correctly with mach.
One thing tho, I`am still not able to get into download mode with the firmware downloader, at this point I don`t need it but maybe in the future it
will be needed for firmware upgrades.
Michael van Wissen
The problem with not being able to connect to the mach software was a configuration in the mach software, not all the six axis were enabled.
This gives the error I got, now I`am able to use it correctly with mach.
One thing tho, I`am still not able to get into download mode with the firmware downloader, at this point I don`t need it but maybe in the future it
will be needed for firmware upgrades.
Michael van Wissen