Hello Guest it is April 26, 2024, 12:00:36 AM
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
| Filename | Downloads | Message |
Posted
|
|---|---|---|---|
| Gantry_Left_Inside_Piece.DXF | 390 | works in 2.0, goes nuts in 2.02 | August 06, 2007, 10:37:34 AM |
| CJs_Mach3Mill.xml | 339 | Re: Motors turn in Kcam, but not mach. What on earth am I doing wrong? | January 31, 2007, 08:49:47 AM |
Guest