Messages

1

General Mach Discussion / Re: Mach3 does not move axis at all in demo mode

« on: November 07, 2021, 07:35:30 AM »

When trying to install mach3 support on windows xp I get an error:

"Unable to open output file"

Please assist.

2

General Mach Discussion / Re: Mach3 does not move axis at all in demo mode

« on: November 07, 2021, 07:33:44 AM »

The usb will provide the 5v power but the parallel will provide communications?

3

General Mach Discussion / Re: Mach3 does not move axis at all in demo mode

« on: October 10, 2021, 02:41:31 PM »

Thank you so much. Really appreciate the assistance.

Last 2 questions please.

Will a parallel port to usb cable work for communications to computer?? (like attached)

And will I still need the 5v usb for power if I am using a parallel port cable?

4

General Mach Discussion / Re: Mach3 does not move axis at all in demo mode

« on: October 10, 2021, 06:27:30 AM »

there is a slot for usb.

Will usb to usb work?

And need to have 32 bit windows 10?

Does mach3 work on raspberry pi?

5

General Mach Discussion / Re: Mach3 does not move axis at all in demo mode

« on: October 10, 2021, 05:40:26 AM »

Seems the the issue is with the driver.

No driver appears in device manager and when I try to add the mach3.inf file as a driver I receive the error attached

Please assist.

6

General Mach Discussion / Mach3 does not move axis at all in demo mode

« on: October 05, 2021, 04:05:54 AM »

Had an existing cnc router with control panel RichAuto dsp 11 went down.

Changed over and recabled everything according to Mach3 breakout board for x-axis and y-axis and spindile
VFD comes on Mach3 board comes on with two solid RED lights.

Do I need a license to get this working??