Messages

1

Mach3 under Vista / Re: Mach3 USB or Ethernet card that can run both x and z axes at same time in manual

« on: September 30, 2021, 09:41:20 AM »

Thank you

2

Mach3 under Vista / Re: Mach3 USB or Ethernet card that can run both x and z axes at same time in manual

« on: September 30, 2021, 06:33:22 AM »

Thank you for your prompt response. I searched for the ESS warp9. It seems very costly. Can you tell me some cheap solution for that. Like any other ethernet card can do that. Can EC300 solve this problem ?

3

Mach3 under Vista / Mach3 USB or Ethernet card that can run both x and z axes at same time in manual

« on: September 29, 2021, 10:36:38 AM »

when press up and right key on old LPT port mach3 board like mach3V2.1-L, one can realize that both x and z axes are capable of moving simultaneously. So want to shift to such a usb or ethernet card that can do that. In LPt port the issue i am facing is the output relays turning on while the computer is starting, this is a safety issue i want to eliminate. I tried some usb breakout boards but couldnt find such a board that can move both axes simultaneously.