1
Newfangled Mill Wizard / Re: Does it really work in metric?
« on: May 20, 2019, 02:06:50 PM »Thanks for that, as I'm only looking at the moment I don't have a licensed copy and the demo mode doesn't produce Gcode. I was reluctant to go too far down the rabbit hole with software that I found an apparent bug on the first attempt to use it. That said it does look like it is just the level of simplicity I need.
It would seem the bug is probably confined to the tool path display since as you point out the Gcode will just repeat the first Z parameters. The excessive Z depths do appear to be 25.4 times the first hole and when I swap to Imperial it all works fine.
My mill conversion is nearing completion so I need to finalise my software choices soon.