1
General Mach Discussion / Re: Mach3 Win7 Jog-mode enabled prohibits entering axis values
« on: December 01, 2022, 07:03:19 AM »
P.S.:
It appears that DROs can be set without a problem when Jog mode is on on a second
installation of Mach 3 I just did on my laptop for testing.
So I assume the problem on my machine must be something in the Pokeys setup or similar rather then in Mach3 itself.
I'll do some more experimenting.
It appears that DROs can be set without a problem when Jog mode is on on a second
installation of Mach 3 I just did on my laptop for testing.
So I assume the problem on my machine must be something in the Pokeys setup or similar rather then in Mach3 itself.
I'll do some more experimenting.