1
Show"N"Tell ( Your Machines) / Re: Ref all home -> goto zero Overshoots/limit activation
« on: December 11, 2018, 01:55:17 PM »
So I did a bit more testing with a new computer it would seem that the error arises when the controller has been on for about 60 minutes.
If I try to go to 100 mm the Machine goes 105 ish..
But it seems odd to me that the dro reads 105 when I put in 100,
As I understand the dro shows the pulses sent by the program, but why would mach send out 105 when asked for 100...
It would make more sense to me if the controller was shot so that mach would read 100 but the controller misfired the last 5...
I'm wirering up my parallel Bob later tonight....grrr
If I try to go to 100 mm the Machine goes 105 ish..
But it seems odd to me that the dro reads 105 when I put in 100,
As I understand the dro shows the pulses sent by the program, but why would mach send out 105 when asked for 100...
It would make more sense to me if the controller was shot so that mach would read 100 but the controller misfired the last 5...
I'm wirering up my parallel Bob later tonight....grrr