1
General Mach Discussion / Re: Very odd !!! Multi pass holes are stepped
« on: May 21, 2016, 10:33:26 PM »
Checked and aspire is correct.
Am starting to think it is play in the temporary belt drives.
Am cutting new drives from ally, which is why the stress over bearing fit.
Can get around the problem with a full depth pass to clean up. Will do that and finish the new drives and then see what we get with them installed.
Thanks for your thoughts
Am starting to think it is play in the temporary belt drives.
Am cutting new drives from ally, which is why the stress over bearing fit.
Can get around the problem with a full depth pass to clean up. Will do that and finish the new drives and then see what we get with them installed.
Thanks for your thoughts