1
General Mach Discussion / Re: Spindle
« on: July 20, 2013, 05:40:49 PM »
OK scrap the first post! Found out I needed a breakout board to buffer the voltage.
Now I have a C10 from CNC4PC Parallel Port Interface Card hooked into the Parallel Port. I need to wire it up to the C6 Variable Speed Control Board also from CNC4pc. I have the VFD wiring figured out but need help with wiring the C10 to the C6. Instructions are not very plain. Can anybody help me with this? Has anybody had to do this?
Now I have a C10 from CNC4PC Parallel Port Interface Card hooked into the Parallel Port. I need to wire it up to the C6 Variable Speed Control Board also from CNC4pc. I have the VFD wiring figured out but need help with wiring the C10 to the C6. Instructions are not very plain. Can anybody help me with this? Has anybody had to do this?