1
General Mach Discussion / Re: Rhino ST/5 or ST/6 Lathe and MACH3
« on: February 06, 2013, 09:39:18 AM »
I was wondering how this project turned out.
I also have an ST/6 I am planning on converting to MACH3 and wondered if you had any pointers. I am planning on using a KBIC-120 DC motor speed controller for the spindle and normal stepper drivers for X and Z. Mine also has the pneumatic tool changer that I was planning on controlling with an Arduino as a Modbus slave.
Thanks!
I also have an ST/6 I am planning on converting to MACH3 and wondered if you had any pointers. I am planning on using a KBIC-120 DC motor speed controller for the spindle and normal stepper drivers for X and Z. Mine also has the pneumatic tool changer that I was planning on controlling with an Arduino as a Modbus slave.
Thanks!