1
LazyCam (Beta) / Re: LazyCam & Mach3 HELP
« on: February 01, 2009, 01:53:19 PM »
Hi Budman
Yes i do have the tools setup
Yes i have watched the videos
I just did a test with a 1/8" marker and after it was drawn the dimensions are ok
I then changed the tool to a 1/4" and did the same test and the whole thing is off by 1/4" bigger
Now maybe with the offset on the outside will give me the exact dimensions well wont know that till i get the registered version of Lazycam Pro.
Yes i do have the tools setup
Yes i have watched the videos
I just did a test with a 1/8" marker and after it was drawn the dimensions are ok
I then changed the tool to a 1/4" and did the same test and the whole thing is off by 1/4" bigger
Now maybe with the offset on the outside will give me the exact dimensions well wont know that till i get the registered version of Lazycam Pro.