1
General Mach Discussion / Re: Jerky movement running code, but jog is OK!
« on: July 15, 2015, 08:33:44 PM »
Problem Solved!
Miscommunication about the "CV FEEDRATE" button on the Settings Screen... Turns out it actually had been set.
The onsite operator re-checked the setting, and turned it off.... system runs as it should!
He turned it back on to verify it was the source of jerkiness, and proved it was!
Thanks, Gerry (CNCZone - ger21) for the directions he followed to resolve this issue.
Paul
Miscommunication about the "CV FEEDRATE" button on the Settings Screen... Turns out it actually had been set.
The onsite operator re-checked the setting, and turned it off.... system runs as it should!
He turned it back on to verify it was the source of jerkiness, and proved it was!
Thanks, Gerry (CNCZone - ger21) for the directions he followed to resolve this issue.
Paul