Messages

71

Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM

« on: December 17, 2009, 01:56:00 PM »

Rich ,

Since your bore size will be approx .14 , I wouldn't worry about the rifeling , since your not going to shoot it.

Ed

72

Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM

« on: December 16, 2009, 06:50:58 PM »

I can see where a wire edm would come in handy for this job, but , sorry , don;t have one.

Ed

73

Show"N"Tell ( What you have made with your CNC machine.) / Re: M1 MILLING MODEL

« on: December 12, 2009, 09:38:36 PM »

Rich,

Take the judge and scale up for 12 gauge. Then , find someone to shoot it.
Hell , I have a double barrel 410/45 long colt derringer. 

Ed

74

General Mach Discussion / Re: engraving bit?

« on: December 12, 2009, 08:32:22 PM »

THE ones on the last post web page are the best. I use the 30 degree.
 Or in a pinch , a small center drill.
Or I grind my own.

Ed

75

Show"N"Tell ( What you have made with your CNC machine.) / Re: M1 MILLING MODEL

« on: December 11, 2009, 09:56:01 PM »

Rich ,

Why scale down ? I'd scale up and make bigger bangs.

Ed

76

Show"N"Tell ( Your Machines) / Re: My Balding Beaver

« on: December 04, 2009, 07:08:26 PM »

BEAUTIFUL looking control panel you did there Hood.
How do you find the time? Seems your always on this forum helping everyone else.
Keep up the good work. 

Ed

77

General Mach Discussion / Re: Does computer spec. affect output?

« on: December 04, 2009, 07:03:23 PM »

Try a little more ram,  It should have enough on the cpu. Some are running below specs with no problems.

Ed

78

General Mach Discussion / Re: Does computer spec. affect output?

« on: December 04, 2009, 04:20:15 PM »

How much below spec?

Ed

79

General Mach Discussion / Re: Whose Fault Is ThIs?

« on: November 30, 2009, 08:16:33 PM »

Ray ,

Yes , the quill drive will be the quickest and most profitable way to go. Keep the knee servo for tool length offsets.

Ed

80

General Mach Discussion / Re: Whose Fault Is ThIs?

« on: November 30, 2009, 06:19:59 PM »

Well , now, then.
Seems to me a while back I put a post in this forum about not driving the Knee for the Z axis. Maybe , just maybe , this is one of the reasons, along with a few more.  

Ed