3851
Brains Development / Re: Aiming axis
« on: February 05, 2016, 03:21:05 AM »
Could you not just use Tangential Control ??
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Please help with this if you can?
I am a new beginner. I purchased mach3 which appears to have installed ok but I had to install a parallel port (com 3) the address for this that I was told to use is 0x040 can anyone tell me if this is correct please?
The software seems to run okay but I get no movement from the cnc 3040T. I am hoping this is because the port address is wrong. I am running vista any asdvice would be appreciated and could stop me jumping out the window
In that case is there anything that M3 can do that M4 can't? and....
will I understand the answer ;-)
Tweakie, are you still on M3 because of the hassle and downtime upgrading.
Thanks guys...