Topics

1

General Mach Discussion / odd problem

« on: January 20, 2008, 08:51:43 AM »

I am in the process of building a new CNC plasma table so I am currently running the trial version of Mach 3 plasma to test out my axis movement. I am running into an odd problem though. When using Mach 3 Plasma I can control the Y axis, but I get no movement from the X axis. After swapping a bunch of stuff around I determined that the driver and motors were all OK. I also checked all the port and motor tuning setup and still no success. On a hunch though I tried Mach 3 mill and everything worked just fine. I cross checked all the settings in mill back to what I had in plasma and it matched, but still no luck with the X axis on the plasma version??

Any suggestions?