Topics

1

General Mach Discussion / y axis vibration

« on: July 05, 2023, 09:47:52 AM »

What makes y axis shutter when moving this is a new install of mach3?
this is a slaved drive one on each side of the table

2

General Mach Discussion / loosing steps

« on: March 18, 2023, 07:49:02 PM »

what would make a machine loose steps
using mach 3 with cnc4pc c62 break out board and teknic cpm-sdsk-2310S-RLN motors
set up machine and all was good for about 3 months.
then one morning the first cutout the ending cut did not line up with where it started
first thought motor was going bad swapped out for new motor ran motor setup per teknic
still off swapped new controll wires still no good
the longer the g-code file the more it is off
this is only happening on the X axis Y axis is good
did the axis calibration per mach
anybody have any ideas what to check next
thanks in advance
KE8MIR