Topics

1

General Mach Discussion / Program Just stops

« on: November 11, 2023, 03:20:50 PM »

Ok, have been using Mach 3 on old computer and had minor issues.  Upgraded to new computer and better board(pokeys 57 cnc board).  Now have issue with every program.  It either will not load and I have to cancel then reset then regen tool path.  The sometimes machine moves and cuts one thing and just stops and I cant reset program and spindle keeps going.  It also will cut and then on z retract just stops and shuts spindle off.  Any input would help as I am about to stop using this and upgrade to Centroid.  I am in the middle of a project that in the past has taken me 3 hours to cut 6 pieces to got 2 cut because of the program acting up.