Topics

1

Mach4 General Discussion / G code will not run

« on: February 20, 2020, 02:38:40 AM »

New to forum and the world of CNC.  Using Mach 4, ESS and getting most parts from CNN Router Parts.   I have been building the cnc router for awhile.  I was getting the basics figured out and about to cut some air.  Everything was working fine homing, soft limits, hard limits,calibration etc.  Then nothing happened when I pushed the start G code button and the MDI also would not run.  I can load G code files and tried a number of then but no luck. I can enter MDI code but nothing happens.  Both of the above functions have worked in the past. I have the feeling that I am probably overlooking something obvious but after a few days working on it I could use some help.
Thanks in advance
Dan