Topics

1

General Mach Discussion / Hot key code

« on: May 11, 2017, 08:15:51 AM »

How do I do hotkey for OEM Trig#2 to Hot key 1000

2

General Mach Discussion / Create feed hold with input leg 15

« on: May 10, 2017, 04:45:34 PM »

I'm going to make feed team with pin 15
I choose OEM Trig # 2
Why does it still think there are limits and an alarm
What can I do ??

3

General Mach Discussion / Hot key code

« on: May 09, 2017, 03:24:58 PM »

How do I find Hotkey code on eg "cycle start" <Alt-R> and "Feed Hold" <spc>

4

General Mach Discussion / 2 bob on one mach3

« on: April 14, 2017, 06:29:26 AM »

Hi

Hope bit of help with getting 2 bob to run with the same Mach3.
I have a bob on my pc lpt port as function 100%

http://www.ebay.com/itm/CNC-6-Axis-DB25-Breakout-Board-Interface-Adapter-MACH3-KCAM4-EMC2-DB25-Cable-/121480961528?hash=item1c48d45df8:g:8OYAAOSwBP9UXDKU

Now I have bought an extra bob to my PC and an LPT3 port.
How do I get it made active in Mach3 so it can work with two bob at once?
My computer says this about the LPT3 EE00-EE07
I changed the port address to 0xEE00 in mach3
My new bob to be run along with the other is a

http://www.ebay.com/itm/4-Axis-CNC-Breakout-Board-For-Stepper-Driver-Controller-mach3-for-Arduino-/291827967497?hash=item43f24d6609:g:MsMAAOSwqfNXljQL

5

General Mach Discussion / LPT 3 adresse

« on: April 11, 2017, 04:01:32 PM »

I just bought a new lpt port to run with two bob.
What should I write in the address field of Mach3 ??

6

General Mach Discussion / New Feed Hold button

« on: April 08, 2017, 11:49:55 AM »

How I made so I can use an input to "Feed Hold" ??
I have input available on my bob (P13)

7

General Mach Discussion / Rapid feed

« on: April 07, 2017, 03:31:41 PM »

Is not it possible in an easy way to allow rapid traverse of 10% and keep g01 feed to 100%

8

General Mach Discussion / Motor turning

« on: February 11, 2017, 10:38:54 AM »

Hi

Can you see what data should be as standard in the motor turning ??( For mach 3)
I have X Y X axis stepper motor 23HS8430

9

General Mach Discussion / axis is cloed

« on: February 11, 2017, 08:43:03 AM »

I run mine shafts with keyboard. if I write go y 5o it is only my display that move ??

10

General Mach Discussion / y axis are mirror

« on: February 11, 2017, 08:40:51 AM »

min y axis are mirror from the ?? How I return it?