Guest
Show Posts
1
General Mach Discussion / Incorrect movement for X & Y
« on: January 13, 2017, 02:50:56 AM »
Hi guys, new to here and hope you all are having good time.
Back to my question, I have recently built up my first 6040 3 axes machine and it was working fine in the past few weeks!
Somehow I don't know since when the X and Y axis are actually not moving fully according to my command when I set zero at and different location within the working area. It has no problem if I start from the zero of machine coordinate after "Ref all".
Once I set zero for example at x100y100, then I type in command g0x10y10 then the machine will go to 9.9992 on either or both axes.
If both X and Y also stop at 9.9992 then when I click "go to zero" then they will back to the zero point.
If one of the axes did go to 10 after the command, when I click "go to zero", this axis will come back at 0.0008.
I didn't have this problem before but somehow it starts to play like this!
Since it constantly has the 0.0008 but not a different value therefore I believe there may be a setting issue?
There is no problem for Z axis.
I hope the explanation is clear enough and please help on this issue.
Thanks in advance!
Cheers!
Back to my question, I have recently built up my first 6040 3 axes machine and it was working fine in the past few weeks!
Somehow I don't know since when the X and Y axis are actually not moving fully according to my command when I set zero at and different location within the working area. It has no problem if I start from the zero of machine coordinate after "Ref all".
Once I set zero for example at x100y100, then I type in command g0x10y10 then the machine will go to 9.9992 on either or both axes.
If both X and Y also stop at 9.9992 then when I click "go to zero" then they will back to the zero point.
If one of the axes did go to 10 after the command, when I click "go to zero", this axis will come back at 0.0008.
I didn't have this problem before but somehow it starts to play like this!
Since it constantly has the 0.0008 but not a different value therefore I believe there may be a setting issue?
There is no problem for Z axis.
I hope the explanation is clear enough and please help on this issue.
Thanks in advance!
Cheers!